Main : Chicken Plucker : chix_plucker_c.jpg

Homestead Collective Photo Gallery

Chicken Plucker : chix_plucker_c.jpg

Prototype radial chicken plucker: front view. Front end mounting is enhanced by flattening out the curvature of the top of the cap around the mounting hole using a Dremel grinder wheel and using a soft rubber washer underneath the metal washer. The backing mount inside the endcap also used a thick soft rubber washer next to the PVC, followed by a large lock washer sandwiched between two regular washers and an extra-long nut.

All images on this page are (C) 2005-2019 and are protected by federal and international intellectual property laws. Unauthorized use is expressly forbidden.

Previous Photo   Next Photo

Chickens  |  Chicken Plucker  |  Easy Lean-to  |  Gamebirds  |  Goats  |  Goatbarn  |  Pets  |  Plants 

Email a link to this page to: (email addresses are not retained)

Last updated 11 December 2019.
(c) 2005-2021
All images (c) 2005-2021 unless otherwise noted
Best viewed with CSS and JavaScript enabled.
Hosted by the The Homestead Collective.